FixVault
Home › Pontiac › 2004 › GTO Automatic › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Repair Instructions › Seat Belt Buckle Replacement - Front › Installation Procedure

Installation Procedure

  1. Install the seat belt buckle and pretensioner assembly (1). Secure with the bolt (2).

    Tighten:  Tighten the seat belt buckle and pretensioner assembly bolt to 42.5 N.m (31 lb ft).

    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: When installing the seat belt buckle and pretensioner assembly, ensure that the front locating pin is aligned with the seat frame.
    Fig 1: View Of Seat Belt Buckle & Pretensioner Assembly
    GM1344317Courtesy of GENERAL MOTORS CORP.
  2. Secure the wiring harness to the underside of the seat using wire ties.
  3. On the driver's seat, connect the seat belt buckle switch connector (3) to the seat.
  4. Connect the seat belt buckle pretensioner connector (4) to the seat.
  5. Install the front seat. Refer to Seat Replacement - Front Bucket in Seats.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 in SIR.
About FixVault