FixVault
Home › Pontiac › 2004 › GTO Standard › Repair and Diagnosis › Suspension › Front Suspension › Front Suspension System › Repair Instructions › Front Lower Control Arm Rod Insulator Bushing Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Lower Control Arm
    GM1386893Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The washer (10) for the front of the lower control arm rod (9) is for reducing caster.
  1. If equipped, ensure the washer is on the front of the rod.
  2. Install the insulator bushing (2) over the front of the rod.
  3. Install the insulator bushing to the studs on the frame.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 4 nuts (1) in order to retain the insulator bushing to the frame.

    Tighten:  Tighten the nuts to 23 N.m (17 lb ft).

    5. IMPORTANT: Do not tighten the nut yet.
  5. Install a NEW nut (11) in order to retain the rod to the insulator bushing.
  6. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
  8. With the weight of the vehicle on the tire and wheel assemblies, push down on the front bumper 3 times in order to stabilize the suspension.
  9. Tighten the nut that retains the rod to the insulator bushing.

    Tighten:  Tighten the nut to 148 N.m (109 lb ft).

  10. Measure the wheel alignment. Adjust the wheel alignment if necessary. Refer to Measuring Wheel Alignment in Wheel Alignment.
About FixVault