Removal Procedure
- Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Remove the front door water deflector. Refer to Water Deflector Replacement - Front Door .
- Raise the window far enough in order to gain access through the inner door panel to the window guide channel to window bolts.
- Remove the bolts (2) that attach the window guide channel to the window.
Courtesy of GENERAL MOTORS CORP.
- Raise the window to the full up position and tape in place.
- Disconnect the electrical connector (2) from the power window motor by pulling out on the tab (1).
Courtesy of GENERAL MOTORS CORP.
- Loosen the bolt on the window regulator motor (5).
- Lift the motor free of the retaining slot.
- Remove the bolts from the front door window regulator (1, 2, 3, 4).
Courtesy of GENERAL MOTORS CORP.
- Remove the window regulator and motor through the access opening in the inner door panel.
- Remove the power window motor from the window regulator. Refer to Window Regulator Motor Replacement - Front Door .