Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake fluid pressure sensor (2) to the EBCM (1).
Tighten: Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).

Fig 1: Brake Fluid Pressure Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling and Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
Perform the Auto Bleed Procedure. Refer to ABS Automated Bleed Procedure .
Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - ABS .