FixVault
Home › Pontiac › 2004 › Vibe GT › Repair and Diagnosis › Engine Performance › System › Engine Control System (Introduction) -- 1.8L (LNK) › Repair Instructions › Heated Oxygen Sensor Replacement - Position 1 › Installation Procedure

Installation Procedure

IMPORTANT: The HO2S 1 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating prior to installation.
    Fig 1: HO2S 1, Wiring Pigtail And Body Plug
    GM851410Courtesy of GENERAL MOTORS CORP.
  1. Install the HO2S 1 (2) into the exhaust pipe.
    2. NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  2. Tighten the HO2S 1.

    Tighten:  Tighten the HO2S 1 to 44 N.m (32 lb ft).

  3. Install the HO2S 1 wiring pigtail and body plug (1) into the floor pan.
  4. Lower the vehicle.
    5. Fig 2: Carpet, Retaining Pin, And Front Floor Console
    GM851369Courtesy of GENERAL MOTORS CORP.
  5. Connect the HO2S 1 electrical connector.
  6. Install the carpet (2) around the front floor console (3).
  7. Secure the carpet to the front floor console with the retaining pin (1).
About FixVault