FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › Brakes › Antilock Brake System And Traction Control System › Repair Instructions › Wheel Speed Sensor Jumper Harness Replacement - Rear › Installation Procedure

Installation Procedure

    Fig 1: Rear Wheel Speed Sensors Component View
    GM305363Courtesy of GENERAL MOTORS CORP.
  1. Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to the rear strut (2).
    2. Fig 2: Locating Rear Wheel Speed Sensor Jumper Harness Retaining Clips
    GM230413Courtesy of GENERAL MOTORS CORP.
  2. Install the rear wheel speed jumper harness (1) into the retaining clips (2).
  3. Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
  4. Lower the vehicle.
  5. Turn the ignition switch to the RUN position, with the engine off.
  6. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
About FixVault