FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 117 (Front Suspension System) › Repair Instructions › Lower Control Arm Bushings Replacement (Horizontal) › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Secure the lower control arm in a vise.
    3. Fig 1: Nut, Washer, Bearing, J 21474-5 & Puller Bolt
    GM1171032Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use a 1/2 x 20 in standard thread nut with the puller bolt.
  3. Assemble the bushing removal tools as indicated:
    1. The nut (1)
    2. The J 21474-01  washer (2). See Special Tools and Equipment .
    3. The J 21474-01  bearing (3). See Special Tools and Equipment .
    4. The J 21474-5  (4). See Special Tools and Equipment .
    5. The J 21474-01  puller bolt (5). See Special Tools and Equipment .
  4. Tighten the puller bolt (5) until the bushing is removed.
  5. Disassemble the J 21474-01  and. See Special Tools and Equipment .J 21474-5  . See Special Tools and Equipment .
About FixVault