FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 117 (Front Suspension System) › Repair Instructions › Wheel Bearing/Hub Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub & Splash Shield
    GM357695Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub with the splash shield as noted during removal.
    2. CAUTION: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install NEW wheel bearing/hub bolts.

    Tighten:  Tighten the NEW wheel bearing/hub bolts to 130 N.m (96 lb ft).

  3. Install the brake rotor and caliper. Refer to Brake Rotor Replacement - Front (RPO J65, JL9) in Disc Brakes.
  4. Install the front wheel drive shaft nut. Insert a drift on a flat-bladed tool into caliper and rotor to prevent the rotor from turning.

    Tighten:  Tighten the front wheel drive shaft nut to 160 N.m (118 lb ft).

    5. Fig 2: Wheel Speed Sensor Electrical Connector
    GM477813Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the connector clip engages the bracket properly.
  5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
    6. Fig 3: View Of Wheel Speed Sensor, Connector And Harness
    GM188809Courtesy of GENERAL MOTORS CORP.
  6. Connect the wheel speed sensor electrical connector (2), if equipped.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
About FixVault