FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 12 (Interior Trim) › Repair Instructions › Console Replacement - Overhead › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drivers information center module to the overhead console.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the drivers information center module screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 1: Installing Overhead Console
    GM788711Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the overhead console, apply a foam type tape to the wiring harness to relocate and secure the wiring harness in the proper position to the headliner.
  3. Apply foam tape to the wiring harness at the headliner.
  4. Connect the electrical connector to the overhead console.
    5. Fig 2: Overhead Console & Electrical Connector
    GM546559Courtesy of GENERAL MOTORS CORP.
  5. Position the overhead console to the mounting bracket in the headliner.
  6. Install the overhead console pressing into place to fully seat the retainers (1).
    7. Fig 3: Engaging Console Retainers
    GM788716Courtesy of GENERAL MOTORS CORP.
About FixVault