FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Control System 3.8L (Introduction)) › Repair Instructions › Air Cleaner Intake Duct Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the intake air temperature (IAT) sensor electrical connector (3).
  2. Remove the IAT sensor with a twisting and pulling motion.
  3. Loosen the air cleaner intake duct clamp.
  4. Remove the air cleaner intake duct from the air cleaner cover.
  5. Remove the air cleaner intake duct from the throttle body.
    6. Fig 1: Disconnecting IAT Sensor Electrical Connector
    GM760425Courtesy of GENERAL MOTORS CORP.
About FixVault