FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Control System 3.8L (Introduction)) › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right splash shield cover. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical-3.8L.
  5. Disconnect the crankshaft position (CKP) sensor electrical connector.
  6. Remove the CKP sensor shield (1).
    7. Fig 1: CKP Sensor Shield
    GM12302Courtesy of GENERAL MOTORS CORP.
  7. Remove the CKP sensor bolts.
  8. Remove the CKP sensor.
    9. Fig 2: CKP Sensor
    GM12303Courtesy of GENERAL MOTORS CORP.
About FixVault