FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 24 (Seat System) › Repair Instructions › Seat Replacement - Front Bucket › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front bucket seat into place.
  2. Engage the seat hook attachments to the floor pan.
  3. Tip the seat forward and connect the following connectors, if equipped:
    • The power seat electrical connector
    • The electrical seat heater connector
    • The driver side air bag electrical connector
    4. Fig 1: View Of Front Seat Bolts
    GM305124Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts that secure the front bucket seat adjuster to the floor pan.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

  5. Install the adjuster track covers. Refer to Seat Adjuster Track Cover Replacement - Front .
  6. Install the seat belt anchor plate nut.

    Tighten:  Tighten the nut to 42 N.m (31 lb ft).

    7. Fig 2: Identifying Seat Belt Anchor Plate Nut
    GM370568Courtesy of GENERAL MOTORS CORP.
  7. Install the head restraint. Refer to Head Restraint Replacement - Front Seat .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  9. Inspect the seat for proper operation and adjustment.
  10. Position the seat to the original position.
About FixVault