FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 24 (Seat System) › Repair Instructions › Trim Panel Replacement - Front Seat › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power seat switch to the front seat cushion trim panel, if equipped. Refer to Seat Switch Replacement - Power .
  2. Install the lumbar control switch to the front seat cushion trim panel, if equipped. Refer to Lumbar Switch Replacement .
  3. Install the heated seat switch to the front seat cushion trim panel, if equipped. Refer to Heated Seat Switch Replacement - Front (Impala)  or Heated Seat Switch Replacement - Front (Monte Carlo) .
  4. Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.
    5. Fig 1: Installing Recliner Handle Hole Retaining Clips
    GM522216Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the front cushion trim panel rear screws.

    Tighten:  Tighten the front seat cushion trim panel screws to 3 N.m (27 lb in).

    6. Fig 2: Installing Front Cushion Trim Panel Rear Screws
    GM522222Courtesy of GENERAL MOTORS CORP.
  6. Install the push-in retainer to the front of the front seat cushion trim panel, pressing into place until fully seated.
    7. Fig 3: Installing Front Seat Cushion Trim Panel Push-In Retainer
    GM522223Courtesy of GENERAL MOTORS CORP.
  7. Install the front seat lumbar knob, pressing into place until fully seated.
    8. Fig 4: Front Seat Lumbar Knob
    GM522225Courtesy of GENERAL MOTORS CORP.
  8. Install the front seat back recliner handle, pressing into place until fully seated.
    9. Fig 5: Installing Front Seat Back Recliner Handle
    GM522228Courtesy of GENERAL MOTORS CORP.
About FixVault