FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 32 (Body Front End) › Repair Instructions › Front Fender Liner Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drill out the plastic rivets from the front fascia extension corner to front fender liner, if equipped.
    2. Fig 1: Front Fascia Extension Corner Plastic Rivets
    GM738910Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the front fender liner at the front bumper fascia.
    3. Fig 2: Removing Screws From Font Fender Liner
    GM456724Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the stud at the rear of the front fender liner.
    4. Fig 3: Removing Nut From Rear Stud
    GM456721Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolt from the front tab of the front fender liner at the lower engine compartment side rail.
    5. Fig 4: Removing Bolt From Front Tab
    GM456723Courtesy of GENERAL MOTORS CORP.
  5. Remove the screws from the front fender liner.
    6. Fig 5: Removing Front Fender Liner Screws
    GM739317Courtesy of GENERAL MOTORS CORP.
  6. Drill out the plastic rivet from the front rocker panel to front fender liner, if equipped.
  7. Remove the front fender liner.
About FixVault