Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the coolant recovery reservoir (3) onto the lower retainer and the shock tower studs.
- Install the coolant recovery reservoir nuts (2) to the shock tower studs.
Tighten: Tighten the nuts to 3.3 N.m (29 lb in).
- Lubricate the reservoir hose with clean water. Route the hose to the radiator overflow neck fitting.
- Install the coolant reservoir hose (1) to the overflow neck fitting.
- Install the reservoir hose and clamp (1), with the clamp tabs at the 11 o'clock position, to the radiator overflow fitting on the radiator filler neck. The hose end must be flush against the radiator filler neck. Seat the clamp squarely between the radiator filler neck and the flared end of the fitting.
- Fill the coolant recovery reservoir to the proper level.
NOTE:
Refer to Fastener Notice in Cautions and Notices.