FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 35 (Wiper System & Washer System) › Repair Instructions › Washer Solvent Container Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the washer solvent from the washer solvent container.
  2. Remove the washer solvent container filler neck. Refer to Washer Solvent Container Filler Neck Replacement .
  3. Remove the right headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement (Impala) or Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement (Monte Carlo) in Lighting Systems.
  4. Remove the washer solvent container screws.
    5. Fig 1: Removing Water Solvent Container Screws
    GM815206Courtesy of GENERAL MOTORS CORP.
  5. Remove the front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  6. Disconnect the washer pump hose.
  7. Disconnect the washer pump electrical connector.
  8. Disconnect the washer solvent level sensor electrical connector.
    9. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  9. Remove the washer solvent container bracket screw.
    10. Fig 3: Washer Solvent Container Bracket Screw
    GM815209Courtesy of GENERAL MOTORS CORP.
  10. Remove the washer solvent container from the right frame rail.
About FixVault