Scan Tool Data List
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Powertrain Control Module Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank Request Signal | Engine Data 2 | Yes/No | No |
| GEN L-Terminal Signal Command | Engine Data 2 | % | 0% |
| Ignition 1 Signal | Engine Data 1,2 | Volts | 12.6 V |
| Starter Enable Relay Circuit Status | Output Driver Data | Fault/OK/Invalid State | OK |
| Starter Relay Command | Engine Data 2 | On/Off | Off |
Body Control Module (BCM) Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Electronics Battery Feed | Data, Inputs | Volts | 12.6 Volts |
| Load Management Status | Outputs | Active / Inactive | Inactive |
| Inadvertent Power Relay | Outputs | On/Off | On |
Transmission Control Module Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| IMS | Transmission Data | Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, INVALID | Park |