Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
- Install the master cylinder to the vacuum brake booster.
- Install the master cylinder mounting nuts.
Tighten: Tighten the master cylinder mounting nuts to 33 N.m (24 lb ft).
- Remove the plugs from the brake pipes
- Connect the brake pipes to the master cylinder.
Tighten: Tighten the brake pipe fittings at the master cylinder to 15 N.m (11 lb ft).
- Connect the electrical connector to the brake fluid level sensor.
- Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.