FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 60 (Rear Suspension System) › Repair Instructions › Strut, Strut Component and/or Spring Replacement › Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coil spring and upper strut mount to the J 45400  .
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
  3. Install the strut to the coil spring and upper strut mount.
    4. Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the strut retaining nut.

    Using the J 42991  and a 45 TORX® socket, install the strut mount nut.

    Tighten:  Tighten the strut mount nut to 85 N.m (63 lb ft).

    5. Fig 2: Removing/Installing Strut Retaining Nut
    GM1079158Courtesy of GENERAL MOTORS CORP.
  5. Remove the strut from the J 45400  .
  6. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
About FixVault