FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 93 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 2 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
  2. When enabling the SIS proceed to step 3, if the roof rail module needs enabling then go to step 7.
    3. Fig 1: View Of Inflatable Restraint Side Impact Sensor (SIS)
    GM863414Courtesy of GENERAL MOTORS CORP.
  3. Install the left SIS connector (3) to the SIS (1).
  4. Install the SIS CPA to the SIS connector (3).
  5. Replace and secure the water deflector back over the SIS.
  6. Install the left/driver door trim panel. Refer to Trim Panel Replacement - Side Front Door in Doors.
    7. Fig 2: Locating Sunroof Components
    GM902186Courtesy of GENERAL MOTORS CORP.
  7. Connect the left roof rail module wiring harness yellow connector (2) to the left roof rail module (3).
  8. Install the CPA to the left roof rail module connector (2).
  9. Install the left rear sail panel. Refer to Sail Panel Replacement in Interior Trim.
    10. Fig 3: Locating SIR Fuse
    GM465618Courtesy of GENERAL MOTORS CORP.
  10. Install the SIR Fuse.
  11. Close the underhood fuse center cover.
  12. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  13. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .
About FixVault