FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 93 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 3 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
    2. Fig 1: Identifying I/P Module Connector To Vehicle Harness Connector (LH Side I/P)
    GM812533Courtesy of GENERAL MOTORS CORP.
  2. Connect the steering wheel module coil yellow connector (3) to the vehicle harness yellow connector (1).
  3. Install the CPA to the steering wheel module coil yellow connector (1).
  4. Install the left sound insulator to the I/P (2). Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
    5. Fig 2: Locating SIR Fuse
    GM465618Courtesy of GENERAL MOTORS CORP.
  5. Install the SIR Fuse.
  6. Close the underhood fuse center cover.
  7. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  8. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .
About FixVault