FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Forward Servo Replacement (M15 - FWD) › Installation Procedure

Installation Procedure

    Fig 1: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  1. Install the servo spring.
  2. Install the servo piston assembly.
  3. Install the forward servo cover O-ring.
  4. Install the forward servo cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the forward band servo cover bolts.

    Tighten:  Tighten the forward band servo cover bolts to 12 N.m (106 lb in).

  6. Remove the drain pan from under the forward servo cover.
    7. IMPORTANT: Ensure that the power steering cooler line does not become trapped or damaged during this step.
  7. Use the utility stand in order to raise the frame rear.
  8. Install the NEW frame bolts.
  9. Install the powertrain mounts to the frame.
  10. Install the transaxle mount nuts. Refer to Transmission Mount Replacement - Left .
  11. Install the engine mount nuts. Refer to Engine Mount Replacement - Right in Engine Mechanical - 3.4L and Engine Mount Replacement - Right in Engine Mechanical - 3.6L.
  12. Install the power steering gear to the frame. Refer to Power Steering Gear Replacement in Power Steering System.
  13. Install the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement in Power Steering System.
  14. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement in Front Suspension.
  15. Lower the vehicle.
  16. Remove the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical.
About FixVault