FixVault
Home › Pontiac › 2005 › Aztek Base, FWD › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.4L - Introduction › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of CMP Sensor
    GM16120Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the power steering pump. Refer to Power Steering Pump Replacement (LA1 ) or Power Steering Pump Replacement (LY7) in Power Steering System.
  3. Disconnect the sensor electrical connector.
  4. Remove the attaching bolt.
  5. Remove the sensor.
  6. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
About FixVault