FixVault
Home › Pontiac › 2005 › Aztek Base, FWD › Repair and Diagnosis › External Pages › Different car › Section 91 (Antilock Brake System, Traction Control System & Stability Control System) › Diagnostic Information and Procedures › DTC C0141-C0156 › Test Description

Test Description

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to step numbers on the Diagnostic Table.

  1. 2:  This step determines if the DTC is current.
DTC C0141-C0156

Step Action Yes No
Schematic Reference:  ABS Schematics  
Connector End View Reference: ABS Connector End Views 
1 Did you perform the Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - ABS 
2 
  1. Using a scan tool clear the DTC.
  2. Remove the scan tool from the DLC.
  3. Carefully drive the vehicle above 12 km/h (8 mph) for several minutes.
  4. Turn the ignition switch to the OFF position.
  5. Install a scan tool.
  6. Turn the ignition switch to the ON position, engine off.
  7. Using the scan tool in Diagnostic Trouble Codes, check for DTCs.
Did any one of the DTCs C0141-C0151 reset as a current DTC?		 Go to Step 3  Go to Diagnostic Aids
3 Replace the EBCM. Refer to Electronic Brake Control Module Replacement .
Is the repair complete?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
About FixVault