FixVault
Home › Pontiac › 2005 › Bonneville SLE › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Computer/Integrating Systems › Repair Instructions › Instrument Panel Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Instrument Panel Module Fasteners & Electrical Connectors
    GM428511Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors to the IPM (1).
  2. Install the IPM (1) to the I/P retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fastener.

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

  4. Install the left sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  5. Reprogram the IPM. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM)  or Body Control Module (BCM) Programming/RPO Configuration (DIM)  or Body Control Module (BCM) Programming/RPO Configuration (RIM) .
About FixVault