FixVault
Home › Pontiac › 2005 › G6 Base › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.5L (Lx9) - Introduction › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Removing Fuel Tank Pressure Sensor From Modular Fuel Sender
    GM1236106Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Relieve the system fuel pressure. Refer to Fuel Pressure Relief Procedure .
  3. Drain fuel tank. Refer to Fuel Tank Draining Procedure .
  4. Remove the fuel tank. Refer to Fuel Tank Replacement .
  5. Remove the electrical connector from the fuel tank pressure sensor.
  6. Remove the fuel tank pressure sensor from modular fuel sender.
About FixVault