FixVault
Home › Pontiac › 2005 › G6 Base › Repair and Diagnosis › External Pages › Different car › Section 1099 (Wiper System And Washer System) › Repair Instructions › Windshield Washer Pump Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Washer Solvent Container Level Sensor Electrical Connector
    GM1207514Courtesy of GENERAL MOTORS COMPANY
  1. Position the washer pump terminal seal (6) to the washer solvent container (1), pressing in until fully seated.
  2. Using full strength windshield washer solvent as a lubricant on the terminal seal, position the washer pump (5) to the washer solvent container (1) pressing in until fully seated.
  3. Connect the washer pump electrical connector.
  4. Connect the washer pump hose (2) to the washer pump (5).
  5. Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  6. Fill the washer solvent container with washer solvent.
  7. Inspect the washer system for proper operation.
About FixVault