Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connector to the sliding door jamb switch.

Fig 1: View Of Door Jamb Switch

Courtesy of GENERAL MOTORS CORP.

Install the sliding door jamb switch to the pillar.

NOTE: Refer to Fastener Notice .

Install the screw to the sliding door jamb switch bracket.
Tighten: Tighten the screw to 6 N.m (53 lb in).
Close the sliding door in order to reset the sliding door jamb switch.