FixVault
Home › Pontiac › 2005 › G6 Base › Repair and Diagnosis › Steering › Power Steering › Power Steering System › Repair Instructions › Tie Rod Replacement - Inner › Installation Procedure

Installation Procedure

  1. Remove any old Loctite® from the threads of the rack and inner tie rod.
    2. Fig 1: Inspecting Inner Tie Rod Threads
    GM861804Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The threads must be clean prior to thread locker application. Do not use too much thread locker, only enough to evenly coat the threads.
  2. Apply Loctite 262® or equivalent to the inner tie rod threads.
    3. Fig 2: Installing Inner Tie Rod End To Steering Gear
    GM861815Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT:
    • The steering gear rack must be held stationary during inner tie rod installation.
    • Protect the steering gear rack teeth when installing the inner tie rod end.
  3. Use the J 34028  to install the inner tie rod to the steering gear. See Special Tools .

    Tighten:  Tighten the inner tie rod to 95 N.m (70 lb ft).

  4. Slide the shock damper into position.
    5. Fig 3: Removing & Installing Outer Tie Rod End From Inner Tie Rod End
    GM862158Courtesy of GENERAL MOTORS CORP.
  5. Install the steering gear boot. Refer to Rack and Pinion Boot Replacement - On Vehicle .
  6. Install the tie rod jam nut on the inner tie rod end. Turn the nut on the same number of threads recorded in removal.
  7. Install the steering gear. Refer to Power Steering Gear Replacement .
  8. Install the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Set the front toe. Refer to Front Toe Adjustment in Wheel Alignment.
About FixVault