FixVault
Home › Pontiac › 2005 › G6 Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - Introduction & Repair Instructions › Repair Instructions › Vehicle Speed Sensor (VSS) Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing & Installing Transaxle Output Speed Sensor
    GM893903Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring onto the output speed sensor.
  2. Install the output speed sensor into the transaxle case.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the output speed sensor stud.

    Tighten:  Tighten the speed sensor stud to 11 N.m (8 lb ft).

  4. Connect the electrical connector.
  5. Lower the vehicle.
About FixVault