FixVault
Home › Pontiac › 2005 › GTO Standard › Repair and Diagnosis › External Pages › Different car › Section 79 (Engine Controls (Introduction)) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS CORP.
  1. Remove the generator bracket assembly. Refer to Generator Bracket Replacement in Engine Electrical.
  2. Remove the camshaft position sensor mounting bolts (1).
  3. Remove the camshaft position sensor assembly (4, 5, 6) from the front cover (7).
  4. Disconnect the camshaft position sensor jumper harness (2) and the engine harness (3) electrical connectors.
  5. Remove the camshaft sensor assembly (4, 5, 6).
  6. Disconnect camshaft position sensor (5) from the jumper harness (4).
About FixVault