FixVault
Home › Pontiac › 2005 › GTO Standard › Repair and Diagnosis › External Pages › Different car › Section 79 (Engine Controls (Introduction)) › Repair Instructions › Fuel Hose/Pipes Replacement - Engine Compartment › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Chassis Fuel Pipe, Fuel Feed Hose & Fuel Rail
    GM329571Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the chassis fuel pipe and the fuel rail pipe.
  2. Connect the fuel feed hose (2) to the chassis fuel pipe (3). Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  3. Connect the fuel feed hose (2) to the fuel rail (1). Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    4. Fig 2: Left Fuel Rail Cover
    GM43560Courtesy of GENERAL MOTORS CORP.
  4. Tighten the fuel filler cap.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (7.0L) in Engine Electrical.
  6. Perform the following procedure in order to inspect for leaks:
    1. Turn the ignition switch ON for 2 seconds.
    2. Turn the ignition switch OFF for 10 seconds.
    3. Turn the ignition switch ON.
    4. Inspect for fuel leaks.
  7. Install the left fuel rail cover.
  8. Program the transmitters. Refer to Transmitter Programming (Domestic and Japan) or Transmitter Programming (Export - Including Canada) in Keyless Entry.
About FixVault