FixVault
Home › Pontiac › 2005 › Grand Am SC/T › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Controls - 2.2L - Introduction) › Repair Instructions › Throttle Position (TP) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
    2. Fig 1: View Of Idle Air Control (IAC) Valve & Throttle Position (TP) Sensor
    GM783168Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the throttle position (TP) sensor harness connector (2).
  3. Remove the throttle TP sensor screw.
  4. Remove the TP sensor and seal.
About FixVault