FixVault
Home › Pontiac › 2005 › Sunfire Automatic › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Battery Positive Cable Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Transmission Electrical Plug
    GM620361Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the new cable in the vehicle in the same location as the old cable.
  2. Install the positive battery cable to the starter solenoid nut.

    Tighten:  Tighten the positive battery cable to starter solenoid nut to 17 N.m (13 lb ft).

  3. Tape the cables together at the transmission electrical connector.
    4. Fig 2: View Of Taped Battery Cables
    GM620364Courtesy of GENERAL MOTORS CORP.
  4. Tape the cables together at the battery tray.
  5. Install power lead bolt to fuse/relay center.
  6. Install fuse/relay center.
    7. Fig 3: Locating Positive Battery Cable
    GM620362Courtesy of GENERAL MOTORS CORP.
  7. Install the positive battery cable end onto the battery.

    Tighten:  Tighten the battery positive cable terminal bolt to 15 N.m (11 lb ft).

  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  9. Install the outlet duct and resonator. Refer to Air Cleaner Assembly Replacement in Engine Controls.
About FixVault