FixVault
Home › Pontiac › 2005 › Sunfire Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls - 2.2L - Introduction › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the front air deflector, if applicable.
  4. Remove the starter. Refer to Starter Motor Replacement in Engine Electrical.
    5. Fig 1: View Of Crankshaft Position (CKP) Sensor
    GM770823Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  6. Remove the CKP sensor bolt.
  7. Remove the CKP sensor.
About FixVault