FixVault
Home › Pontiac › 2005 › Vibe Base, AWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - Mu5 › Repair Instructions › Overdrive Switch Replacement › Installation Procedure

Installation Procedure

  1. Install the OVERDRIVE switch wires into manual selector knob.
  2. Snap the OVERDRIVE switch into the manual selector knob.
    3. Fig 1: Remove Selector Sleeve and Retaining Screw
    GM862488Courtesy of GENERAL MOTORS CORP.
  3. Install the OVERDRIVE wires through the manual selector lever sleeve, then secure the sleeve with the lower screw.
    4. Fig 2: Manual Selector Knob Button Removed
    GM862461Courtesy of GENERAL MOTORS CORP.
  4. Install the manual selector knob onto manual selector assembly, then install the shift button.
    5. Fig 3: Manual Selector Knob Retaining Screws
    GM862456Courtesy of GENERAL MOTORS CORP.
  5. Fully seat the manual selector knob on the assembly, then tighten the 2 screws.
    6. Fig 4: Manual Selector Push Clip And Connector
    GM862451Courtesy of GENERAL MOTORS CORP.
  6. Install the 2 white OVERDRIVE switch wires into the OVERDRIVE switch/manual selector illumination lamp electrical connector (2).
  7. Hook the 2 white OVERDRIVE switch wires onto the clip (1) on the manual selector base, then secure with a push clip.
  8. Install the OVERDRIVE switch/manual selector illumination lamp electrical connector (2) into the manual selector assembly.
  9. Install the manual selector assembly into vehicle. Refer to Manual Selector Replacement .
About FixVault