Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front transaxle mounting bracket on the transaxle assembly.
Tighten: Tighten the bolt to 64 N.m (47 lb ft).
Install the left transaxle mounting bracket on the transaxle assembly.
Tighten: Tighten the bolt to 52 N.m (38 lb ft).
Position the transaxle on the front suspension crossmember.

Fig 1: Transaxle To Engine Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 6 transaxle to engine retaining bolts.
Tighten:
- Tighten the bolts (1) to 64 N.m (47 lb ft).
- Tighten the bolt (2) to 46 N.m (35 lb ft).
- Tighten the bolts (3) to 23 N.m (17 lb ft).

Fig 2: Front Transaxle Mount Through Bolt

Courtesy of GENERAL MOTORS CORP.

Install the front mount through bolt.
Tighten: Tighten the bolt to 52 N.m (38 lb ft).
Install the transfer case assembly on the transaxle. Refer to Transfer Case Replacement in Transfer Case - Vibe.
Connect the 3 electrical connectors to the transaxle.

Fig 3: Ground Cables And Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 2 bolts and ground cables to the transaxle.
Tighten: Tighten the bolts to 10 N.m (7 lb ft).
Install the engine and transaxle as an assembly in the vehicle. Refer to Engine Replacement in Engine Mechanical - 1.6L (LV6).

Fig 4: Flywheel-To-Torque Converter Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The anodized (gold colored) bolt must be installed first. This bolt is to insure proper alignment for the other 5 bolts.

Install the 6 torque converter bolts.
Tighten: Tighten the bolts to 28 N.m (20 lb ft).
Install the starter assembly in the vehicle. Refer to Starter Motor Replacement in Engine Electrical.
Install the flywheel inspection cover
Install the drain plug with a new gasket.
Tighten: Tighten the drain plug to 49 N.m (36 lb ft).
Lower the vehicle.
Fill the transaxle with 2.9 L (3.06 qt) of T-IV (GM Part No. 88900925).