FixVault
Home › Pontiac › 2005 › Vibe GT › Repair and Diagnosis › Engine Performance › System › Engine Control System - 1.8L (LNK) - Introduction › Repair Instructions › Ignition Coil(s) Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Ignition Coil And Bolt
    GM830280Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coils (3) to the engine.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Secure the ignition coils with the fasteners (4).

    Tighten:  Tighten the ignition coil fasteners to 9 N.m (80 lb in).

  3. Install the electrical harness (2) and secure with the 2 fasteners (1).

    Tighten:  Tighten the fasteners to 8.8 N.m (78 lb in).

  4. Connect the electrical connectors to the ignition coils (3).
    5. Fig 2: View Of Engine Upper Cover
    GM828878Courtesy of GENERAL MOTORS CORP.
  5. Install the engine cover (1) to the engine.
  6. Secure the engine cover (1) with the four fasteners.

    Tighten:  Tighten the fasteners to 7 N.m (62 lb in).

About FixVault