FixVault
Home › Pontiac › 2006 › Grand Prix Base › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Battery Replacement (RPO LS4) › Installation Procedure

Installation Procedure

IMPORTANT: Do not tip the battery more than 40 degrees during installation.
    Fig 1: View Of Battery Retainer & Bolts
    GM1552777Courtesy of GENERAL MOTORS CORP.
  1. Install the battery.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the battery retainer (2) and bolts (1).

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

    3. Fig 2: View Of Right Front Of Engine Compartment
    GM1552766Courtesy of GENERAL MOTORS CORP.
  3. Install the positive battery terminal (2) to the battery.
  4. Tighten the positive battery terminal nut.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  5. Position the positive battery cable terminal cover.
  6. Reposition and install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
  7. Install the right front diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal .
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32)  or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .
About FixVault