FixVault
Home › Pontiac › 2006 › Grand Prix Base › Repair and Diagnosis › External Pages › Different car › Section 193 (Battery, Charging System And Starting System) › Repair Instructions › Generator Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Bracket Bolts - 3.6L
    GM887707Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the generator bracket bolts in the sequence shown.

    1. Tighten the generator bracket bolts (1) to 50 N.m (37 lb in).
    2. Tighten the generator bracket bolts (2) to 50 N.m (37 lb in).
    3. Tighten the generator bracket bolt (3) to 23 N.m (17 lb in).
  3. Install the belt tensioner. Refer to Drive Belt Tensioner Replacement .
  4. Install the coolant inlet pipe lower bolt from the generator bracket.
  5. Install the generator. Refer to Generator Replacement (3.8L)  or Generator Replacement (3.6L) .
About FixVault