FixVault
Home › Pontiac › 2006 › Solstice Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - 2.4L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement-Intake › Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: CMP Sensor Electrical Connector
    GM1591857Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake CMP sensor electrical connector (1).
About FixVault