Scan Tool Output Controls

Body Control Module (BCM)

Scan Tool Output Control	Additional Menu Selection(s)	Description
Interior Lamps	Output Control/Lamp Test	The body control module (BCM) turns the interior lamps ON when you select ON. The interior lamps should stay ON until commanded OFF.
I/P Illumination Lamps	Output Control/Lamp Test	The BCM turns the instrument panel illumination lamps on when you select ON. The illumination lamps should stay on until commanded OFF.
Transmission Range Indicator	Output Control/Lamp Test	The BCM turns the PRNDL indicators ON when you select ON. The PRNDL should stay ON until commanded OFF.

Instrument Panel Cluster (IPC)

Scan Tool Output Control	Additional Menu Selection(s)	Description
Lamp and Gauge Check		The instrument panel cluster (IPC) illuminates the following indicators when you select ON: ABS Air Bag BRAKE Charge Fasten Safety Belt High Beam Liftgate Ajar Low Fuel Low Oil Pressure Low Traction Reduced Engine Power Security Tire Pressure Monitor Traction OFF The IPC drives the following gages to maximum position when you select ON: Engine Coolant Temperature Gage Fuel Gage Speedometer Tachometer The indicators should stay illuminated and all gages remain at maximum until commanded OFF. When commanded OFF, the indicators should turn OFF and all gages should remain at the minimum position until the test is exited or commanded ON.

Scan Tool Output Control

Additional Menu Selection(s)

Description

Lamp and Gauge Check

The instrument panel cluster (IPC) illuminates the following indicators when you select ON:

ABS
Air Bag
BRAKE
Charge
Fasten Safety Belt
High Beam
Liftgate Ajar
Low Fuel
Low Oil Pressure
Low Traction
Reduced Engine Power
Security
Tire Pressure Monitor
Traction OFF

The IPC drives the following gages to maximum position when you select ON:

Engine Coolant Temperature Gage
Fuel Gage
Speedometer
Tachometer

The indicators should stay illuminated and all gages remain at maximum until commanded OFF. When commanded OFF, the indicators should turn OFF and all gages should remain at the minimum position until the test is exited or commanded ON.