FixVault
Home › Pontiac › 2006 › Vibe Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 26 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Sensing and Diagnostic Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of SDM Assembly And Fasteners
    GM819439Courtesy of GENERAL MOTORS CORP.
  1. Install the SDM assembly (1) into the vehicle, taking care to ensure that the connectors are pointing toward the rear of the vehicle.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 3 SDM fasteners (2).

    Tighten:  Tighten the fasteners to 17.5 N.m (13 lb ft).

  3. Install the SDM electrical connectors.
  4. Install the under seat duct.
  5. Install the center console and then install the rear console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 4 .
About FixVault