FixVault
Home › Pontiac › 2006 › Vibe GT › Repair and Diagnosis › Engine Performance › System › Engine Control System - 1.8L (LNK) - Introduction (2 Of 2) › Repair Instructions › Accelerator Controls Pedal Replacement › Installation Procedure

Installation Procedure

    Fig 1: View of Accelerator Cable and Throttle Lever
    GM236863Courtesy of GENERAL MOTORS CORP.
  1. Connect the accelerator pedal to the pedal lever. Secure the pedal with one pin, a spring, and a retainer.
  2. Connect the accelerator pedal and the pedal lever to the vehicle.
    3. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Secure with the 2 bolts (3).

    Tighten:  Tighten the bracket bolts to 10 N.m (89 lb in).

  4. Connect the accelerator cable to the accelerator pedal lever.
About FixVault