Test Description

The numbers below refer to the step numbers on the diagnostic table.

2: This checks to see if DTC C0252 is set.
3: This step checks to see if the DTC C0252 resets.
4: This step checks to see if VSES data list parameters are correct.
5: This step checks the components harness connectors for poor connections.

DTC C0252

Step	Action	Yes	No
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Install a scan tool. Turn ON the ignition, with the engine OFF. Select the ABS DTC display function. Does the scan tool display any DTC other than DTC C0252?	Go to Diagnostic Trouble Code (DTC) List - Vehicle	Go to Step 3
3	Use the scan tool in order to clear the DTC. Perform the Diagnostic Test Drive . Use the scan tool to select the ABS DTC display function. Does the DTC reset?	Go to Step 4	Go to Diagnostic Aids
4	Use the scan tool to select the VSES data list. Compare data to the typical values located in the electronic brake control module (EBCM) scan tool data list under Vehicle Stability Enhancement System (VSES) Data List. Refer to Scan Tool Data List . Are all parameters correct?	Go to Step 5	Go to Testing for Intermittent Conditions and Poor Connections
5	Check the wiring harness connectors for the following: EBCM Brake pressure sensor Steering angle sensor Yaw/lateral accelerometer sensor LF wheel speed sensor (WSS) RF WSS RF WSS RR WSS Did you find and correct the condition?	Go to Step 6	Go to Testing for Intermittent Conditions and Poor Connections
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK