Installation Procedure

Fig 1: Inflatable Restraint I/P Module

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the inflatable restraint I/P module nuts.
Tighten: Tighten the nuts to 10 N.m (89 lb in).
Route the PSIR wire harness under the locating rib and attach the metal edge clips to the I/P trim pad.
Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .

Fig 2: I/P Module Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the inflatable restraint I/P module bracket bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .