FixVault

Installation Procedure

  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Position the inflatable restraint side impact sensor by the door.
  3. Fig 1: Identifying Side Impact Sensor (SIS) Connector
    GM834331Courtesy of GENERAL MOTORS CORP.
  4. Connect the side impact sensor connector (4).
  5. Install the CPA (3) to the side impact sensor connector (4).
  6. Fig 2: View Of Inflatable Restraint Side Impact Sensor (SIS)
    GM863414Courtesy of GENERAL MOTORS CORP.
  7. Install the side impact sensor (1) to the door (4).
  8. NOTE: Refer to Fastener Notice .
  9. Align the locating pin on the sensor (1) to the opening in the door (4).

    Begin tightening the side impact sensor bolts (2).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  10. Install the water deflector to the door.
  11. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  12. Enable the SIR system. Refer to SIR Disabling and Enabling .