Ignition Lock Cylinder Case Replacement

Fig 1: View Of Ignition Housing Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure:  Remove the ignition lock cylinder case. Refer to MULTIFUNCTION TURN SIGNAL SWITCH HOUSING REPLACEMENT .
1	Ignition Lock Cylinder Case Bolt NOTE: Refer to FASTENER NOTICE in Cautions and Notices. Procedure:  Use a small chisel and hammer to back out the ignition lock cylinder case bolt counterclockwise and remove it. When installing a new ignition lock cylinder case bolt continue to tighten it until the head shears off.
2	Ignition Lock Cylinder Case Strap
3	Ignition Lock Cylinder Case Disconnect any electrical connectors as needed. Procedure Tip: The ignition lock cylinder must be turned to the run position in order to remove and/or install the ignition lock cylinder case.