FixVault
Home › Pontiac › 2007 › Vibe Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Stone Shield, Four Retainers And Two Bolts
    GM830841Courtesy of GENERAL MOTORS CORP.
  2. Remove the two bolts (3) that secure the stone shield (1).
  3. Remove the four retainers (2) and the stone shield (1).
    4. Fig 2: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the CKP sensor electrical connector.
  5. Remove the one hold down bolt (2).
  6. Remove the CKP sensor (1) from the front cover of the engine block.
About FixVault