FixVault
Home › Pontiac › 2007 › Vibe Standard › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - Introduction (2 Of 2) › Repair Instructions › Knock Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Knock Sensor And Nut
    GM848007Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter motor. Refer to Starter Motor Replacement .
  2. Disconnect the knock sensor (KS) electrical connector.
  3. Remove the nut (1) securing the KS (2) to the engine block.
  4. Remove the KS (2) from the engine block.
About FixVault